iSeries program call not running?

Post any question you may have in regards to GoAnywhere Director and let our talented support staff and other users assist you.
2 posts Page 1 of 1


Posts: 7
Joined: Fri Jun 20, 2014 10:00 am

Post by wfpturner » Tue Jun 24, 2014 9:04 am
XML code is attached.

When I execute my project, it gets to the EXEC400 step and appears to be stuck. The "processing" icon stays on the screen until I shut it down and cancel the execution. The CL program being called should run in barely a second.

On the iSeries, I found the job but it doesn't show much in the job log. I've attached a text file that shows the call stack. I cancel the execution after about 5 minutes. Should I just let it run longer? Could it be an authority issue? I just can't tell anything based on the as400 and GAD job logs.


Support Specialist
Posts: 592
Joined: Tue Jul 17, 2012 2:12 pm
Location: Phoenix, AZ

Post by Support_Rick » Wed Jun 25, 2014 12:49 pm

Please review your IBMi connection and make sure your environment is set correctly for the CLP to run as needed. Don't forget that you can perform ADDLIBLE as well as other commands all within the same exe400 Task before you execute your CLP.
Rick Elliott
Lead Solutions Consultant
(402) 944.4242
(800) 949-4696
2 posts Page 1 of 1