I'm working with my first monitor to trigger a project. The monitor checks for new files on an sftp resource every 4 hours. If a new file is found it will trigger project. I unknowingly had an problem with my project and as a result when 2 new files were discovered the project ran but failed.
Now it appears the snapshot considers these files as old. Since these files did not transfer as expected, is there a way to reset something so the monitor detects those two files?
My attempts to manually pass the file name through a project level variable was not successful (I think because I attempted to pass a single file name variable through on a source files variable).
All input welcomed, thanks
monitor- modify monitor.fileList
Post any question you may have in regards to GoAnywhere Director and let our talented support staff and other users assist you.
- Support_Rick Offline
- Support Specialist
- Posts: 590
- Joined: Tue Jul 17, 2012 2:12 pm
- Location: Phoenix, AZ
- Contact:
Re: monitor- modify monitor.fileList
There are a couple options for you at this point.
1- Rename the files on the Source Server and have your Monitor kick in again with the new file names.
2- Tweak your Project to generate a new file list once it makes the connection and retrieve what's there
3- Have your Project loop through the list and go retrieve each file individually instead of as part of a FileList var.
Either one of the three above should help you get the file(s)
1- Rename the files on the Source Server and have your Monitor kick in again with the new file names.
2- Tweak your Project to generate a new file list once it makes the connection and retrieve what's there
3- Have your Project loop through the list and go retrieve each file individually instead of as part of a FileList var.
Either one of the three above should help you get the file(s)
Rick Elliott
Lead Solutions Consultant
(402) 944.4242
(800) 949-4696
Lead Solutions Consultant
(402) 944.4242
(800) 949-4696