RUNPROJECT iSeries Mode default value
Post any question you may have in regards to GoAnywhere MFT and let our talented support staff and other users assist you.
If you need a quicker response, please create a support ticket via the customer portal my.goanywhere.com or contact our support team by email at [email protected].
If you need a quicker response, please create a support ticket via the customer portal my.goanywhere.com or contact our support team by email at [email protected].
RUNPROJECT iSeries Mode default value
When using the RUNPROJECT command on the iSeries, what is the default value for the MODE? i.e. does it default to *INTER or *BATCH if the mode is not specified?
- Support_Rick Offline
- Support Specialist
- Posts: 590
- Joined: Tue Jul 17, 2012 2:12 pm
- Location: Phoenix, AZ
- Contact:
Re: RUNPROJECT iSeries Mode default value
The default is the value that comes up in the Command Prompt ... *INTER (Interactive)
Rick Elliott
Lead Solutions Consultant
(402) 944.4242
(800) 949-4696
Lead Solutions Consultant
(402) 944.4242
(800) 949-4696